3D printer grinding filament solution
By Steve Lowry 2018-09-07 7790 0
Increase printing temperature
If you have been encounter the problem like that, try to increase the temperature of the nozzle by 5 to 10 degrees so that the plastic extrusion is easier. You can modify the print temperature settings. There is a printing temperature in the basics. When you slice, you can set a new one and print it in a slice. Plastics are always easier to extrude when the temperature is high, so this is a very useful setting that can be adjusted.
Print speed is too fast
After raising the temperature, if you still have problems with the grit, the next thing you need to do is reduce the print speed.
By doing so, the motor of the extruder does not have to be rotated at such a high speed, because the filament takes longer to squeeze out. Reducing the motor speed of the extruder helps to avoid the problem of the grit. For example, if your previous print speed is 3600mm/min (60mm/s), try reducing this value by one-third to see if the problem with the grit has disappeared.
Check if the nozzle is clogged
After reducing the temperature and printing speed, if you still have problems with the flake, the nozzle may be clogged. Then you need to clean up the nozzle.
First, if the plugging is not serious, consumables will be intermittent, then you raise the printing temperature to 230 degrees, then use a small needle to spray several nozzles, then manually feed it out to see Whether or not the material can come out normally. If it does not work, then you can replace a new nozzle. Then clean up the inside of the pipe and check if the pipe is normal or not. Sometimes you need to replace it with a new one.
Teflon tube carbonization in the throat
There is a small section of Teflon tube in the throat of the machine. The Teflon tube is resistant to high temperatures, but the Teflon tube will gradually be carbonized when working in a high temperature environment for a long time, resulting in a relatively small Teflon tube.
|You may also want to read:|
|Pick the right 3D printer filament|
|How to stop 3D prints from warping|
|Cura 3D slicing software installation and operation|
|How to solve cracking or breaking of layers during 3D printing|
2020-12-01By Cheryl Evans
2017-03-16By GB Blog Official
2019-08-27By Joe Horner
2017-02-17By GB Blog Official
2017-11-17By GB Blog Official
2018-06-23By Steve Lowry
Next article:How to deal with the 3D printer nozzle jam