AMAZFIT GTR Smartwatch Charging Problems Fix Guide

Step 1: Take out the charging base, match the copper cylinder heads with the stainless steel touch points of the watch, and press it to ensure that they match well enough and there are no obvious gaps.

Step 2: Connect the USB connector on the other end of the charging base to a mobile phone charger with a voltage of DC 5.0 V and an output current above 500 mA to charge your watch (A brand mobile phone charger is recommended), or you may connect the base to your PC for charging.

Yes. It is recommended to use a brand portable power source as the charger, the charging voltage of which is DC 5.0V.
Remarks: There may be an issue with the portable power sources, in that they can't fully charge the watch because most of them has an automatic shut-down function at full energy. the input current into the mobile phones becomes very little when the phones are about to be fully charged, and the portable power sources will shut down the charging process to save energy, so if the watch is about to be fully charged and the current is too little to be detected, the portable power sources may cut off the current as they interpret that the watch has been fully charged.

A fast charger with an input voltage of 5 V may be used to charge your watch.

The most power-consuming functions of the Amazfit GTR watches include motor vibration, GPS positioning and the light of the screen. If you often run for exercise, receive pushed messages frequently, use instant scalping watch face, or set a much too long screen-on duration, then it's normal that your watch runs out of battery power fast.

If you don't use these functions often, fully charge your watch, turn on Do Not Disturb mode, set the brightness of the watch to the lowest level, turn off the Bluetooth, set your watch to the default watch face, and then observe the power consumption after placing it still for 24 hours.

If the power consumption is over 2% (Amazfit GTR 47 mm), 5% (Amazfit GTR 42 mm), please submit your feedback to help us analyze and locate the issue.

The Battery Saver mode can minimize the power consumption of the watch and improve its endurance. With the Battery Saver mode on, the watch will record only steps and sleep time. Other functions are disabled.
To exit the Battery Saver mode, press and hold the Home button.

It may be caused by low battery. If that's the case, it's recommended to charge it for half an hour first, and then you may see the charging icon again.