/
USD Select Regional Settings
Main Features
Regarding product tightness and leakage:
During preheating and after preheating is completed, it is normal that no glue drips within one minute. In addition, the leaking of glue drops in the new machine will be more obvious, because there is air inside the heating head, this problem will get better after using one glue stick. If you mind, please buy carefully.
Note
* Remove the gun cap before use.
* Do not hand touch the working nozzle due to the heat.
* Do not hand touch the melted glue due to the heat.
* The product is not fully charged upon delivery. Charge before use for the first time.
* The product cannot work when charging.
* When use for the first time, press the trigger several times to push the glue stick into the slot to be heated easily.
* After using, if the glue stick is not used up, do not pull it out forcibly to avoid damage.
* lf the status indicator does not display normally when charging again after a long time of non-use, just keep on charging for 30 minutes and observe again.
* Place the product vertically if not in use.
* The product is only applicable for 7mm glue sticks
Specification
Get G Points! Be the FIRST to Write a Review!
See personalized recommendations
New customer? Start here
