30W Trunk Strip Light Red Turn Signals Flowing Led Rear lights Car Braking Light

Main Features

Specifications:
Placement on Vehicle: Rear
To Fit: Brake Light
Led Number: 144LED
Waterproof Rate: IP68
Watt: 30W
Light length: 1M
Line length: 1M

Compatibility instructions:
The length of your rear windshield is at least 1M

If your existing brake light is in the way and is not removable, you will need to make some adjustments to affix the LED brake strip light. If you are trying to install this on an SUV that does not have a sloped windshield, you may be able to create your holding brackets so that you can mount it in your SUV.

Installation:
Step 1: Wipe down the surface so your LED 3rd brake light can properly adhere to the glass surface.?
Step 2: Measure the length of the upper rear windshield so you know where you can line up the roofline LED brake light.
Step 3: Peel off the double-sided tape film and carefully apply the LED third brake light onto the upper rear windshield location. Hold it for 30 seconds to one minute.
Step 4: After it fully adheres, draws the wires to the existing 3rd brake light harness or tap it to the left/right tail light to finish.